Tohle ti nebude fungovat ...

1. potrebujes HTB s IMQ pro RIZENI upload a downlodad ...
2. je to popsane i primo v HTB skriptu:
3. VIZ dole ....

http://www.abclinuxu.cz/clanky/site/...od-do-shapingu

dalsi info tady: # TRIVIAL EXAMPLE
# ---------------
#
# Consider the following example:
# (taken from Linux Advanced Routing & Traffic Control HOWTO)
#
# You have a Linux server with total of 5Mbit available bandwidth. On this
# machine, you want to limit webserver traffic to 5Mbit, SMTP traffic to 3Mbit
# and everything else (unclassified traffic) to 1Kbit. In case there is unused
# bandwidth, you want to share it between SMTP and unclassified traffic.
#
# The "total bandwidth" implies one top-level class with maximum bandwidth
# of 5Mbit. Under the top-level class, there are three child classes.
#
# First, the class for webserver traffic is allowed to use 5Mbit of bandwidth.
#
# Second, the class for SMTP traffic is allowed to use 3Mbit of bandwidth and
# if there is unused bandwidth left, it can use it but must not exceed 5Mbit
# in total.
#
# And finally third, the class for unclassified traffic is allowed to use
# 1Kbit of bandwidth and borrow unused bandwith, but must not exceed 5Mbit.
#
# If there is demand in all classes, each of them gets share of bandwidth
# proportional to its default rate. If there unused is bandwidth left, they
# (again) get share proportional to their default rate.
#
# Configuration files for this scenario:
# ---------------------------------------------------------------------------
# eth0 eth0-2.root eth0-2:10.www eth0-2:20.smtp eth0-2:30.dfl
# ---- ----------- ------------- -------------- -------------
# DEFAULT=30 RATE=5Mbit RATE=5Mbit RATE=3Mbit RATE=1Kbit
# BURST=15k BURST=15k CEIL=5Mbit CEIL=5Mbit
# LEAF=sfq BURST=15k BURST=15k
# RULE=*:80, LEAF=sfq LEAF=sfq
# RULE=*:25
# ---------------------------------------------------------------------------
#
# Remember that you can only control traffic going out of your linux machine.
# If you have a host connected to network and want to control its traffic on
# the gateway in both directions (with respect to the host), you need to setup
# traffic control for that host on both (or all) gateway interfaces.
#
# Enjoy.
#