ATi R600

[crux2005]

hmmm

http://www.forumdeluxx.de/forum/show...&postcount=212

v skratke:

- e6600 standard, r600 @ standard: 13298markov v 3Dmarku06
- C2D E6600 @ 3,2GHz + R600 XTX @ 1,35/3,35 = 18342markov v 3Dmarku06

[tomase]

hmmm

http://www.forumdeluxx.de/forum/show...&postcount=212

v skratke:

No to by asi vela ludom popadali sanky ak by to bola pravda. Bez parcialnych vysledkov 3dmarku je ale tazke nieco dopredu sudit

[Haste]

Jako kdyby tohle:
"C2D E6600 @ 3,2GHz + R600 XTX @ 1,35/3,35 = 18342markov v 3Dmarku06 " byla pravda, coz by odpovidalo moji sestave, tak neni co resit

Pak by onen odklad mel smysl, protoze by si mohli byt jisti, jenom to cekani me zabiji

[no-X]

Považuje se to za fake, neřešil bych to...

[Masster]

R600 Clocks Higher Than 800MHz

Hardspell is reporting that R600 GDDR3 card uses 12 layers PCB while the R600 GDDR4 card uses 12-16 layers PCB. The silicon for R600 only reaches A13 revision and there are no A14, 15 or 17 revisions. According to them, currently all the ATi R600 benchmarks out there aren't real and R600 core clock is not lower than 800MHz. VR-Zone has learned about some updates on R600 availability. Apparently R600 GDDR3 will be available in early May while R600 GDDR4 will be available in mid May but in limited quantities. We will see some R600 demos at CeBIT but behind doors.

http://www.vr-zone.com/?i=4713

[Masster]

AMD talks R600 at 690G chipset launch

On the specifications front, several tidbits were pointed at to give enthusiasts some tea leaves to stir. In the configuration demoed in San Francisco, each R600 is said to have used 200W, be comprised of 320 "multiply-accumulate units", and between the two units on display be capable of a total of one teraflop of math power. While it's not clear yet which bits are definite AMD marketing language and which are reporters trying to invent language to report with, it would appear to us likely that AMD will also be joining the scalar bandwagon, and that to reach 1 teraflop of compute power with 320 ALUs x 2, would most likely imply a clock of roughly 800MHz operating on MADD units. Going well back to early rumours and reporting of R600 last spring, and adding today's 320 ALUs, this would begin to look like a modified/improved version of Xenos at 4 arrays of 16, with the 5D ALUs improved to be scalar and fully MADD. However, AMD's generosity of information today did not extend quite so far as that, and some actual poking and prodding would be required to confirm this.

http://www.beyond3d.com/#news39176

[crux2005]

AMD Demo R600 Crossfire on Quad Core Barcelona Setup

http://www.vr-zone.com/?i=4712