Pcchips M571LMR a novy bios

[KLUBKO]

Zdravicko

Potrebuju helfnout

Kamosovi sem prines novy procik K6-2+ 400Mhz (tusim ARF),je na dva volty do vyse zminene desky.Bios je 51-0702-001437-00101111-071595-M571-007_66M571-H tj. ze 7.02.99 ale bohuzel deska ten procik vubec nerozpozna
tj,ani nenabehne.Vse si nastavuje sama,jumpery nema,2V umi,nasobic 5,5
a fsb 83Mhz.

A ted,na netu maj dve verze biosu jednu 1MB a druhou 2MB(resp.128 a 256Kb tusim v Rom.)Jakou tam mam amifleshem dat?Pomuze to?
A jak ulozim puvodni bios v Amiflashu?Nejak mi to nejde.....
Predpokladam ze procik je v pohode....
Deska ma specifikaci pro prociky K6-2,3 az do 450Mhz
Takze HELP ME.
thanks

[Rainbow]

Pozri sa aky tam mas Flash ROM chip - najlepsie rovno co je na nom napisane (pod nalepkou AMI BIOS alebo co na tom je).

[KLUBKO]

Bohuzel ji nemam u sebe,ale pokud to neco vyresi,brnknu tomu kamosovi.
Ty biosy jsou na http://www.pcchips.com.tw/BIOS.html a jsou tedy dva,navic jen ve verzi LR...asi staci i na tu LMR.

A co stim Amiflashem,jak mam ten bios ulozit?



M571LR
SPECIFICATION

The advanced features of the TXPRO-II mainboard include :

Supports Pentium 90~450MHz Pentium or compatible CPUs at 66/75/83MHz external clock speed in Socket 7 for Baby AT Form Factor.
Supports Intel P54C/P55C, Cyrix/IBM 6x86/6x86L/6x86MX/MII, IDT C6 and AMD K5/K6/K6-2/K6-III CPUs; provides CPU Plug & Play feature for easier CPU installation and auto CPU core voltage switching from 2.0V to 3.5V.

512K Pipeline Burst Synchronous L2 cache on board; provides 2 DIMMs for FPM /EDO / SDRAM memory modules and is expandable up to 512MB.
Embedded Higher performance 64bit Graphics Accelerator with 4MB share memory frame buffer, supports Windows 98 Multiple Display feature.
3D PCI Sound Pro on board, meet PC98' Spec., HRTF Positional Audio supports Microsoft's Direct Sound 3D and Aureal's A3D interface, with 4 channel speaker out; Software Wave-table Synthesizer.
10/100 MHz Fast Ethernet LAN on board, supports IEEE 802.3 and 802.3u standards, and fully compliant ANSI X3.263 TP-PMD physical sub-layer.
56K Fax/Modem on board, supports V9.0 Fax/Modem standard for internet communication.(optional)
2MB Flash Rom on board, provides complete Advances Configuration Power Interface (ACPI) and Legacy PMU and the Ultra DMA 33/66, fully compliant to PC'97 and PC'98 Spec.
Provides ATX power connector, supports various features of ATX power, such as Suspend / Shutdown, Alarm Wake-Up ,Modem Ring On, Wake on LAN, Interrupt Wake-Up from Keyboard/Mouse.
Built-in Hardware Monitor circuit supports thermal, Power and fan speed monitor; supports Intel LANDesk Client Manager (LDCM)(optional).
Bundled AMI Desktop Client Manager detects abnormal condition and thermal automatically or management through the network link.
Supports PC99 Color Connector for easy identification of peripheral devices.
Bundled Super Voice for Fax/Modem and Voice application; MediaRing Talk for Internet Phone communications.

[.:::iGor:::.]

M571LR
SPECIFICATION
...2MB Flash Rom on board, provides complete Advances Configuration Power Interface (ACPI) and Legacy PMU and the Ultra DMA 33/66, fully compliant to PC'97 and PC'98 Spec...

...sam si to sem napisal

[KLUBKO]

Hmm,ale nasel jsem i toto a tam je 1MB verze...
Jeste jak si mam poradit s tim ulozenim toho biosu v Amiflash336?

M571LMR

CPUs
Intel?Socket 7 ZIF Socket
Intel?Pentium?Processor 75 to 233 MHz (P55C/P54C/P54CS)
AMD?K5/K6-2/3 366Mhz , Cyrix?/small> M-II 333
Chipset
Txpro-II
Cache
Onboard 512K Pipeline Burst Cache memory
Video
Embedded SiS 2D Video chip,supports shared system memory up to 4MB.
MEMORY
2x168-Pin DIMM Sockets support 8MB to 512MB SDRAM in 3.3V SDRAM Modules
I/O Expansion Slots
Three 32bit PCI slots
Two 16bit ISA slot
System BIOS
AMI PnP BIOS
1M Flash ROM
10/100 LAN
SiS 900 High Performance 10/100Mbps LAN Ready for (A)DSL or Cable Modem Fully PnP , Support Most of O/S Drivers



Factor and Size
AT Form Factor
8 3/4" x 8 3/4
SOUND & V.90 Fax/Modem
HT8738 Including PCI 3D digital audio and V.90 Pctel Fax/Modem all in one chip. The 3D PCI Sound meet PC98' SPEC and supports HRTF Positional Audio, supports Microsoft's Direct Sound 3D, and Aureal's A3D interface, with 4 channel speaker out; Software Wave-table Synthesizer, and 24 bit Digital Audio Interface Support HRTF 3D Positional Audio Technology with full duplex stereo.Onboard HSP 56Kbps Fax/Modem module supports V.90, V.34, V.32bis, V.32, V.22bis, V.22, MNP5, and Auto Fallback Supports V.42bis data compression with 115200 compatible Virtual UART
ON-BOARD I/O
On-board super Multi-I/O chip that supports two serial ports with 16550 Fast UART compatibility
One parallel port with SPP,EPP or ECP capabilities
One floppy disk drive controller/interface
On-board PCI IDE interface with primary and secondary controllers supporting PIO Mode from 0 to 4 and Ultra DMA/33 at Mode 1 and 2
Supports ATX Form Card (optional) which consists of 1 x PS/2 Mouse Port, 1 x IR Port & 2 x USB Ports

[Rainbow]

LMR je tusim to iste co LR. Jediny rozdiel je myslim v tom ze s LMR sa dodava modemova karta a k LR nie (da sa dokupit). Este existuje MR - bez sietovky - ale BIOS je ten isty. Existuje viac verzii tejto dosky takze sa najprv treba pozriet na verziu. Je to napisane pri klavesnicovom konektore. Na zistenie velkosti chipu sa da pouzit napriklad UniFlash - staci spustit, opisat typ chipu a velkost a skoncit. BIOSy su na http://go.to/ajz

[KLUBKO]

Tak uz mam toho vyrobce biosu tj.tak na tom biosu je todle:

MX J991630
29F001TPC-12
1A4727
TAIWAN

To Rainbow:neco take jsem potreboval,diks

A co s tim ulozenim stavajiciho biosu?

[Rainbow]

29F001TPC -> 128KB = 1mbit
Ak tam nefunguje poriadne AMIFlash, tak skus UniFlash. Jednu M571LMR som mal a UniFlash tam chodil bez problemov. Da sa tym ulozit BIOS co tam je teraz a potom aj flashnut novy (odporucam advanced submenu -> flash including bootblock). PRED flashovanim si skontroluj verziu dosky!!!

[KLUBKO]

Hmm,tak jsem na tebe uplne nedal a zkusil jsem zadat do google to cislo 29F001TPC a nasel jsem naku stranku s DFI,ktere ma vsak stejny svab
na http://www.driver.ru/main.php?file_id=5462 a tam se neco pise o tom
vetsim biosu¨tj tech 260kB.....no jsem z toho uz dost jelen.

S tou verzi desky myslis nejaku verzi PCB ci rozdeleni na LMR.MR ci LR?
Je to stopro LMR.
Take jsem prostudoval ty stranky z toho tveho odkazu http://www.zanmatti.com/pcchips/index.htm a koukam ze mas asi pravdu s tim 1mbit velikosti....
Pochopil jsem z toho ze jsou dve verze M571LMR1 a M571LMR2 lisici se prave tim biosem.Z tech bios release.txt jsem pobral asi to ze ja mam
tu LMR1(uz se opakuju...) a ze tam ten procik nerozchodim protoze ji pobiraji jen ty LMR2(s 2mbits biosy)alspon je to u nich napsany narozzdil od 1mbits verzi...
Takze par otazek pomuze ten flash 1mbit biosu k jeho rozchozeni ,staci i teoreticka sance,deska na to preci hardwarove ma....
a nebo bych mel schanet ten 2mbits svab(muzu to vubec vymenit?)
Ted uz to beru cire sportovne,musim to v tom rozchodit......
Co by se stalo kdybych tam zkusil falshnout tu 2Mbits verzi....

29F001TPC -> 128KB = 1mbit
Ak tam nefunguje poriadne AMIFlash, tak skus UniFlash. Jednu M571LMR som mal a UniFlash tam chodil bez problemov. Da sa tym ulozit BIOS co tam je teraz a potom aj flashnut novy (odporucam advanced submenu -> flash including bootblock). PRED flashovanim si skontroluj verziu dosky!!!

[Rainbow]

Na tej adrese co som pisal su BIOSy podla verzie dosky - v5.0 a pod. Podla toho tam daj spravny BIOS. Ta "1" v 29F001 znamena 1mbit. Keby to bolo 29F002 tak by to bolo 2mbit = 256KB. Myslim ze ten CPU by tam mal chodit. 256KB BIOS tam neflashnes lebo tam nevojde.

[KLUBKO]

Jo,jo tak ted uz mi to je jasny,po vejkendu to tam hodim a jeste se ozvu jak to dopadlo.
Zatim diks.

Na tej adrese co som pisal su BIOSy podla verzie dosky - v5.0 a pod. Podla toho tam daj spravny BIOS. Ta "1" v 29F001 znamena 1mbit. Keby to bolo 29F002 tak by to bolo 2mbit = 256KB. Myslim ze ten CPU by tam mal chodit. 256KB BIOS tam neflashnes lebo tam nevojde.

[KLUBKO]

Tak se ozyvam abych vam povedel jak to dopadlo.
Flashnul jsem tam nejnovejsi bios 1Mbit progaramkem Uniflash(je celkem fajn) a chovalo se to stejne jako predtim tj.komp ani nepostnul.
Jinak je to presne K6-2ACK.

Nastesti mu pocitac beha tak jak ma,pote si kamos nahodou sehnal K62 na 350 a ta mu tam beha.

Tak jsem z toho dost zmateny,asi je v haji ten procik co myslite?

Jeste bych pro nezasvecene chtel uvest se K62 se vyrabela v nekolika verzich a to 0,25 a 0,18um pripadne jako mobilni verze ,ja mam tu 0,18
takze by mohl byt problem asi v tom.

[Rainbow]

Moze byt blby ten procesor alebo je v tom BIOSe nejaka chyba ze to s nim nefunguje. Inak ta funkcia CPU Plug&Play je dost brutalna - funguje to asi tak ze na zaciatku to tam narve nieco nad 3V (aby to fungovalo aj na Pentiu P54C), potom sa rozbehne BIOS a znizi napatie podla toho aky typ CPU zisti.
Ta mobilna verzia K6-2 sa tusim oznacuje K6-2+ a su s nou problemy skoro na vsetkych doskach.

[KLUBKO]

Hmm,to s tim napetim je fakt sila,procik vratim kamosovi a budu tez zvedavej jak je na tom.

Jinac moc dik za rady ,zvlast to Rainbow.Kdyz uz nic, tak jsem si ozivil
stare vzpominky na socket7.

Mějte se.