novy bios

[Peca-on-line]

Zřejmě si tam špatně zadal jméno toho souboru.

11. What if I get an error during flashing?
These are the errors most often encountered while trying to flash the BIOS. If you get one of this errors don't panic, your board has not been flash yet, so go ahead and take care of the problem or reboot if you need to.

Amiflash locks up
This probably means the flash utility is corrupted, or you didn't perform a clean boot. Download amiflash again and try placing it in the hard drive or a cdrom, instead of a floppy.

CRC Error
This means you're probably trying to flash from a floppy disk, and the disk is corrupted. Place the files in the hard drive or a cdrom. Read over the instructions on how to flash the BIOS.

Chipset/Flash part isn't available. The function will be invalid.
This usually happens when you try to flash the BIOS under Windows 9x/ME/2K/XP, you need to do it under DOS. Read over the instructions on how to flash the BIOS.

Error 2 - File does not exist
This means you're telling amiflash to flash a file that doesn't exist. Make sure you include the .rom extension. Ex: "aminf329 011215" gives an error because the BIOS file is named 011215.rom. The correct syntax would be: "aminf329 011215.rom".

Error 9 - BIOS tag is incorrect
This can mean two things, either your BIOS file is corrupt or you're trying to flash a BIOS for a different motherboard. Corruption is unusual but can happen. Delete the BIOS .rom file and download it again. If you're flashing from a floppy disk, download the file again, place it in the hard drive and flash from there.