tak jsem uspesne rozchodil ten disk. pomohlo nechat prvnich cca 50MB (pro jistotu, polovicko by mozna taky stacil) nechat volnych a az potom vytvorit partition. ted beha bez potizi.
zkousel jsem pak jeste ty sektory prepsat nulami nebo je spravit, ale neslo s nimi nic delat. klidne at si tam ted hniji.
tady je jeste vypis ze smartu:
Kód:S.M.A.R.T. status Date: 17 September 2006 18:41:43 Drive model: ST360015A Serial number: 3KC0AGZD Capacity: 60.0 GB Firmware Revision: 3.31 Drive interface: IDE Drive temperature: 39 °C (102 F) -------------------------------------------------------------------------------------------- Attribute Name Threshold Value Worst Raw value -------------------------------------------------------------------------------------------- 1 (01) Raw Read Error Rate 6 67 61 160449926 3 (03) Spin Up Time 0 100 100 0 4 (04) Start/Stop Count 20 100 100 176 5 (05) Reallocated Sector Count 36 100 100 25 7 (07) Seek Error Rate 30 83 60 216304039 9 (09) Power-on Hours Count 0 89 89 9701 10 (0A) Spin Up Retry Count 97 100 100 0 12 (0C) Power Cycle Count 20 99 99 1996 194 (C2) Temperature 0 39 56 39 195 (C3) ECC on the Fly Count 0 67 61 160449926 197 (C5) Current Pending Sector Count 0 100 100 12 198 (C6) Off-line Scan Uncorrect. Sector Count 0 100 100 12 199 (C7) Ultra ATA CRC Error Rate 0 200 200 0 200 (C8) Write Error Count 0 100 253 0 202 (CA) TA Increase Count 0 100 253 0 --------------------------------------------------------------------------------------------