
Původně odeslal
PiT
Tym sa ten program stava uplne nepouzitelny... Ako si mam pamatat, ake WB ma dana fotka, ked to z nej nevie ten program zistit sam?

Musis mu specifikovat, ze chces nejak WB nastavit.
Napr. parametr -a nastavi automatickou, -w dle fotaku atd.
Je to psany jako konzolovej program, takze to i tak funguje - vse pres parametry. Naopak mne se libi ze z toho jdou dostat fakt raw data bez uprav - ty si muzu udelat pak v cem chci.
Kód:
Raw Photo Decoder "dcraw" v8.19
by Dave Coffin, dcoffin a cybercom o net
Usage: d:/marty/prog/dcraw/dcraw.exe [options] file1 file2 ...
Valid options:
-v Print verbose messages
-c Write image data to standard output
-e Extract embedded thumbnail image
-i Identify files without decoding them
-z Change file dates to camera timestamp
-a Use automatic white balance
-w Use camera white balance, if possible
-r <nums> Set raw white balance (four values required)
-b <num> Adjust brightness (default = 1.0)
-k <num> Set black point
-H [0-9] Highlight mode (0=clip, 1=no clip, 2+=recover)
-t [0-7] Flip image (0=none, 3=180, 5=90CCW, 6=90CW)
-o [0-5] Output colorspace (raw,sRGB,Adobe,Wide,ProPhoto,XYZ)
-d Document Mode (no color, no interpolation)
-D Document Mode without scaling (totally raw)
-q [0-3] Set the interpolation quality
-h Half-size color image (twice as fast as "-q 0")
-f Interpolate RGGB as four colors
-B <domain> <range> Apply bilateral filter to reduce noise
-j Show Fuji Super CCD images tilted 45 degrees
-s Use secondary pixels (Fuji Super CCD SR only)
-2 Write 8-bit non-linear PPM (default)
-4 Write 16-bit linear PPM
-3 Write 16-bit linear PSD (Adobe Photoshop)