Mno asi preto ze default asusacky bios v nibitore
nezeditujes tak aby si tam tych 1,4V mal. Takze
si tam asik poriesil iny bios. Navyse jak si precitate
aj textiky co sa zjavia ked kliknes na tie otaznicky
v nibitore...

"A entry consist of a label eg. '1.3V' as identifier for the driver
and the actual VID eg. '03' which is set to the voltage regulator.
You must note that the voltage label is not responsible for the
output voltage, it is only used by the driver to select correct
VID.
So changing e.g. '1.3V' to '1.9V' will NOT give you
voltage of 1.9V, the voltage set by the entry's VID
will still be 1.3V."

Takze jak sis menil napriklad vid table biosu karty Palit,
tak si tak akurat trt nastavil voltaz na 1,4V. Si to sakra
zmeraj a netrep.