uz i P4P800 rev.1, ikdyz zatim ne dokonale:

"Good I have a mother chart p4p800 asus (1ere of the name ] and I tried to place the celeron-m following the setting at the disposal of new a bios beta (1021__3) on the ftp of asus.

Thus boot and recognition of the celeron-m.
In the bios, there is not the possibility of controlling the voltage of the processor...

Even if the agp/pci fix is present, in practice it is impossible to go beyond approximately 150 of fsb.

It is not a problem of vcore because I connected vss to vid4 for a vcore of 1.5v

To approximately 150 of fsb, the graphics board thus makes an error (cheksum bios invalid and search for a bios validates) the agp is undoubtedly not fixed.

For those which will think of clockgen, I tested and frequency CPU increases at the same time as the agp and the NCV.
Edict: except when the fsb is to 133 in the bios, with a memory with 266 report/ratio 1:1
In this case one can modify the frequency of the agp and NCV.
By increasing the frequency of the fsb, the agp and the NCV are fixed.
But actually to 150 of fsb and by making set been worth, there is no more posting...



Here I thus await next the bios...
The p4p800 is finally compatible even if that is not perfect."