Copypaste z helpu nemenovaneho switcha
Excessive CRC/alignment errors
---------------------------------
Description: A high percentage of data errors was detected on this port.
Possible causes: Faulty cabling or topology, half/full duplex mismatch,
a misconfigured NIC, or a malfunctioning NIC, NIC driver, or transceiver.
Actions:
1. If this port is 100Base-T, make sure the cable, connectors, punch-down
blocks, and patch panels connecting to the port are Category 5 or
better. Verify the correctness of the installation using a Category
5 test device.
2. Check the directly-connected device for mismatches in half/full
duplex operation (half duplex on the switch and full duplex on the
connected device, or the reverse).
3. Update the NIC driver software.
4. Verify that the network topology conforms to IEEE 802.3 standards.
5. Replace or relocate the cable. Also check the wiring closet components,
transceivers, and NICs for proper operation.
Kazdopadne, zalezi na tom, kolko CRC errorov na tom porte je, aby sa to seriozne prejavilo aj na performance.
Původně odeslal Helium
Coz o to, ze tam byl vibracema uvolnenej vnitrek konektoru, to jo,
Odpověď s citací