Kód:
SMBus Communication Program 1.18 (C) 2001-2005 by Martin Rehak; rayer^seznam*cz
Compiled by GCC 3.4.3 at 04:29:14, Feb 23 2005 (DOS/Win9X compatability)
Designed for motherboards with southbridge i82371(PIIX4) or i82801(ICHx) only!
i82371 (PIIX4/E) IDE BusMaster controller detected as PCI#0 device 7 h
Vendor ID: 8086 h
Device ID: 7111 h
Controller revision ID: 1 h
BusMaster base address: F000 h
Primary IDE base address: 1F0 h
Secondary IDE base address: 170 h
Detecting channel: primary, secondary
HPT370 IDE-Raid controller detected as PCI#0 device 13 h
Vendor ID: 1103 h
Device ID: 4 h
Controller revision ID: 3 h
BusMaster base address: E000 h
Primary IDE base address: D000 h
Secondary IDE base address: D800 h
Detecting channel: tertiary*, quaternary*
Primary master IDE/ATA non-removable drive info [OK]:
Drive Geometry (C/H/S): 232581/16/63 (LBA sect. 234441648), size = 120034 MiB
Drive Model: ST3120026A, S/N: 5JT4A8WK
Drive FirmWare: 8.01, Cache Buffer: 8192 kB
Max. Block Transfer: 16 sectors/IRQ, ECC: 4 B, DMA, LBA
Minimum MultiWord DMA/PIO/PIO&IORDY cycle time: 120 ns / 240 ns / 120 ns
Current Transfer Mode: Ultra DMA 5 (100 MB/s), max. supported Ultra DMA 6
AAM: unsupported, disabled (current/vendor's default: 0/128)
APM: unsupported, disabled (current APM level: 254)
Security: supported, disabled, unlocked, level = high, Master PWD_RC = FFFE h
Security Erase: unsupported
Other Features: packed commands = no, 48bit addressing, download uCode
S.M.A.R.T: supported, enabled, self-test, error-logging
press any key to continue...
S.M.A.R.T. data rev. 10; 15 valid attributes found, ckecksum: OK
---- ATTRIBUTE NAME ---- VALUE - WORST - THRS ---- RAW --- (* IniVal. ! PFail.)
Raw Read Error Rate: 67 / 62 / 6 / 84595922
Spin-up Time: 97 / 96 / 0 / 0
Start/Stop Count: 100* / 100* / 20 / 3
Reallocated Sector Count: 100* / 100* / 36 / 0
Seek Error Rate: 76 / 60 / 30 / 47528297
Power-on Hours Count: 100* / 100* / 0 / 755 (31.46 days)
Spin-up Retry Count: 100* / 100* / 97 / 0
Start/Stop Cycle Count: 100* / 100* / 20 / 407 (12.94x/day)
Drive Temperature: 32 / 57 / 0 / 32 řC
Hardware ECC Recovered: 67 / 62 / 0 / 84595922
Current Pending Sect.Cnt: 100* / 100* / 0 / 0
Off-line Scan Uncorr.Cnt: 100* / 100* / 0 / 0
UltraDMA CRC Error Rate: 200 / 200 / 0 / 0
Write Error Rate: 100* / 253 / 0 / 0
Data Addr. Mark Errors: 100* / 253 / 0 / 0
press any key to continue...
Primary slave IDE/ATA non-removable drive info [OK]:
Drive Geometry (C/H/S): 77545/16/63 (LBA sect. 78165360), size = 40020 MiB
Drive Model: WDC WD400EB-00CPF0, S/N: WD-WMAAT1298332
Drive FirmWare: 06.04G06, Cache Buffer: 2048 kB
Max. Block Transfer: 16 sectors/IRQ, ECC: 40 B, DMA, LBA
Minimum MultiWord DMA/PIO/PIO&IORDY cycle time: 120 ns / 120 ns / 120 ns
Current Transfer Mode: Ultra DMA 5 (100 MB/s), max. supported Ultra DMA 5
AAM: supported, enabled (current/vendor's default: 254/128)
APM: unsupported, disabled (current APM level: 0)
Security: supported, disabled, unlocked, level = high
Security Erase: unsupported
Other Features: packed commands = no, download uCode
S.M.A.R.T: supported, enabled
press any key to continue...
S.M.A.R.T. data rev. 16; 14 valid attributes found, ckecksum: OK
---- ATTRIBUTE NAME ---- VALUE - WORST - THRS ---- RAW --- (* IniVal. ! PFail.)
Raw Read Error Rate: 200 / 200 / 51 / 0
Spin-up Time: 96 / 91 / 21 / 2575
Start/Stop Count: 98 / 98 / 40 / 2808
Reallocated Sector Count: 199 / 199 / 140 / 2
Seek Error Rate: 200 / 200 / 51 / 0
Power-on Hours Count: 87 / 87 / 0 / 9668 (402.83 days)
Spin-up Retry Count: 100* / 100* / 51 / 0
Calibration Retry Count: 100* / 100* / 51 / 0
Start/Stop Cycle Count: 98 / 98 / 0 / 2700 (6.70x/day)
Reallocated Event Count: 199 / 199 / 0 / 1
Current Pending Sect.Cnt: 200 / 200 / 0 / 0
Off-line Scan Uncorr.Cnt: 200 / 200 / 0 / 0
UltraDMA CRC Error Rate: 200 / 253 / 0 / 8
Write Error Rate: 200 / 200 / 51 / 0
press any key to continue...
IDE_exec_command: IO_base=D800h, drv=0, ATA_cmd=ECh, C/H/S=0/0/0, scnt=0
ERROR: CMD_ABRT MED_CHG_RQ MED_CHG UNCOR_ERR
IDE_exec_command: IO_base=D800h, drv=1, ATA_cmd=ECh, C/H/S=0/0/0, scnt=0
ERROR: CMD_ABRT MED_CHG_RQ MED_CHG UNCOR_ERR
Odpověď s citací