Mno uz jsem o tom cetl a zalezi na tom jak je vysoka ta pamet. Pokud je vyssi jak 40mm, muze se ten heatsink otocit aby byly heatpipes smerem ke GF, ale muze zde nastat problem pokud bude na GF pouzity nejaky masivnejsi chladic, navic SLOT 1 pak nejde obsadit. Pokud jsou pameti nizsi nez zminovanych 40mm, jdou obsadit vsechny 4 sloty bez problemu - zalezi zase na vysce jestli musis sundavat anebo ne hetsink pri manipulaci s pametmi.

Tady jsou nejake obrazky: http://www.xtremesystems.org/forums/...chmentid=23067
http://www.xtremesystems.org/forums/...chmentid=23068
http://www.xtremesystems.org/forums/...chmentid=23069
http://www.xtremesystems.org/forums/...chmentid=23070
http://www.xtremesystems.org/forums/...chmentid=23071

Vyjadreni borce ktery to zkousel:
Ok, it seemes that appearantly I wasn't clear enough so here is a short sum up:

With pipes facing the gfx:
All 4 slots usable, though max ram height is about 40mm, are your modules taller you just can't fit them under there. And if your rams are taller then about 32mm you can't mount them after HS is mounted, and due to the way the HS is mounted (you tip it over towards the slots to get those hooks in the holder) it's going to be quite hard to mount it when rams are already in slots.

Pros: All 4 slots can be populated
Cons: Max ram height is 40mm for slot 3 & 4


With pipes facing the slots:
Slot 1-3 can now be populated with ram with any height. But HS is going to be close to the gfx which could lead to problem with some third parts cooling for gfx. And slot 4 cannot hold any ram, not even low profile.

Pros: slot 3 can now hold high ram modules
Cons: Slot 4 cannot hold any module at all and HS is very close to gfx.


Hoped I cleared everything out no

http://www.xtremesystems.org/forums/...chmentid=23124
http://www.xtremesystems.org/forums/...chmentid=23125 -otoceni XP-120