problem s partition magic 8.0

[epidot]

ahoj, nainstaloval jsem tento partyšn medžyk 8.0 a on mi pri spusteni hodi error s tim ze ,,Partition's drive letter cannot be identified,, a dale nenajede.
Nevite cim by to mohlo byt. Nevim jestli je to tim ze jsem presel na S-ATA disk.Na nem jsem jeste partitiona nepouzival... nebo jestli je pm.8.0 uz moc stary na sata.
dekuji

[Anonymous]

Ja osobne by som sa vykaslal na cely Partition Magic 8.0. Aj Windows XP ti disk rozdeli bez problemov ked ho instalujes v DOSe. Ma to vsak jednu nevyhodu, ze ti vymaze vsetky data z disku.

[mISHA]

2Shoorty: boze na nebesich...

2epidot: na sata to bezi bez problemu. problem bych videl spis jinde. zkousel si ten disk opravit?

eventualne ve spravci disku zkontrolovat, jestli jsou spravne prirazene pismena jednotkam ( zvlast pokud si mel napevno nastavene a pak si cachroval s diskama - to se mi stalo po presunu systemu na sata ).

[Skodik]

Sám mám podobný problém, doteď jsem ho ještě nevyřešil http://4um.ocguru.cz/viewtopic.php?t...hlight=partion

Shoorty: ty ses fakt jednicka v kazde situaci

[epidot]

s nicim jsem necachroval, novy disk - ranish partition manager, tam jsem to rozdelil bez problemu. sil3112 driver a instalace Win...

[mISHA]

#117 Partition’s drive letter cannot be identified
Under OS/2, PartitionMagic must be able to find the drive letter for each partition
before modifications can be made. There are various reasons why OS/2 might not
be able to find a drive letter for each partition. For example, a driver on your
system may change the drive letters from their defaults, or your partitions may
not have serial numbers.
You may also see this error when running PartitionMagic under Windows.
The solution is to run PartitionMagic from DOS or from MS-DOS mode (in
Windows 95 or Windows 9. When PartitionMagic runs from DOS or from
MS-DOS mode, it does not need to be able to find the drive letter for each
partition. Thus, if the problem indicated by this error message is the only
problem, PartitionMagic can run successfully.