skript nemusi mat ziadnu specialnu priponu (ja nepouzivam ziadnu)
syntax bataku mas dobre
netreba ziadny restart
ale asi treba mat pripojeny zivy ethernet kabel aby to fungovalo, neda sa to testovat bez kabla (ale to plati aj ked to menis cez dialogove okno)

ja pouzivam napr. takyto skript (ty to nermas asi uplne):

#========================
# Interface configuration
#========================
pushd interface

reset all


popd
# End of interface configuration



# ----------------------------------
# Interface IP Configuration
# ----------------------------------
pushd interface ip


# Interface IP Configuration for "Local Area Connection"

set address name = "Local Area Connection" source = static addr = 10.0.0.2 mask = 255.255.255.0
set address name = "Local Area Connection" gateway = 10.0.0.138 gwmetric = 1
set dns name = "Local Area Connection" source = static addr = none
set wins name = "Local Area Connection" source = static addr = none


popd
# End of interface IP configuration

a este jedna vec: ked napr spustis skript kde mas specifikovanu gw a neskor spustis iny skript kde gw nebude tak ti zachova tu co si mal predtym, asi to treba v tom skripte upravit na 0.0.0.0 ale to som este nemal cas testovat