Potrebujem ako sa da spojazdnit 15GBdisk na starej doske

[Peter Chovanec]

Potrebujem ako sa da spojazdnit 15GBdisk na starej doske
ide totiz o to ze je tam P133 takze sa moze stat ze ho nebude
vidiet cely alebo ci ho mozem dako zviditelnit a dalej by ma zaujimalo
keby z neho videl len teda cast tak ci to bude fungovat o.k.
viem bios by to vyriesil len neviem ci sa mi podari ho zohnat alebo
ci vyrobca daco ma diky za rady

[MadCap]

ja som uspesne prevadzkoval 15GB disk na p120 pomocou ontrack manageru co je utilitka ibm, ktora je zavedena v MBR. V biose som mal disk ako type1 a normalen slapal ako 15GB inak by mozno aj stacilo mat prvu particiu pod 8GB ale toto je na istotu stiahnutelne snad pre kazdy disk u vyrobcu
MadCap

[Pavouk]

mno nebo třeba linux to umi my na APcku mame na p150 60GB disk taky sem se divil jak to ten PC muze zvladnot

[Peter Chovanec]

ontrack manageru som nenasiel pre disky maxtor

[MadCap]

1. Ontrack manager je od IBM a btw fungoval by ti aj na tom Maxtore je to jedno
2. Asi si tomu nevenoval ziadnu alebo strasne malu snahu, pretoze ja som za 2minuty nasiel toto (no search iba som pribl.blo klikakl )

Capacity of the hard drive is too large for the BIOS to support
On older systems (pre- November 199 the BIOS may not support drives that are larger than 32 GB. If the ATA hard drive you are trying to install has a capacity larger than what the BIOS can support the drive may not be detected by the system.
To troubleshoot this problem follow these steps.
Enter the system BIOS. This is usually accomplished by pressing the F2, Delete, or F1 key when your system is powering on. When you first turn on your computer look for a on-screen message indicating which key to press to enter Setup.
Select User or User defined and enter:
Cylinders = 1024
Heads = 16
Sectors = 63
LBA Mode or IDE Translation Mode = Normal, Standard CHS, or disabled.
These parameters will tell the system that your drive's capacity is 502 MB or 528 MB, a capacity that most, if not all BIOS's can support.
Ignore the Write Pre Comp (WpCom) and Landing Zone (LZ) settings; they can be set to zero.
Save BIOS settings and exit.
Restart the system with MaxBlast. MaxBlast should detect the drive. MaxBlast will install a disk overlay that will allow the BIOS to support the full capacity of the drive.

Note: Windows XP and 2000 users: Please download MaxBlast version 1.30. Older versions of MaxBlast will not support Windows XP and 2000.

kedze vypadas na to ze by si nenasiel ani v tomto texte zmieneny MaxBlast 3 tak tu mas link > http://www.maxtor.com/en/support/dow.../maxblast3.htm
nabuduce pred debilnymi otazkami zapoj mozgove bunky THX
MadCap

[Peter Chovanec]

diky ale ale ja som hladal ten ontrack a nasiel som
len pre maxtor tam nebolo nic tak som myslel
ze treba spec. soft ku kazdemu disku cize ontrack
k maxtoru