od abitu stale nic ale toto som nasiel na abit fore (riesi to data corruption takze mne to nepomoze vobec ale niekomu mozno ano):

Bios 19, Maxtor drives and data corruption
Silicon Image posted on their site that Maxtor ATA133 drives are incompatible on the SATA controller using sirillel adapters that incorporate the Marvell chip. This I have come to believe is due to corruption in mode 6 with this setup. By downgrading to mode 5 I have been able to allieviate the corruption issue and still use the .28 (non-crippled) drivers. I since have upgraded my bios to version 19 on my v1.2 board and done some testing.

I have concluded that the new setting to fix the corruption will allow the use of mode 6 (at least in my case, and hopefully many).

My methodology:

Flash bios 19 and clear cmos.
Reset bios to my configuration with no overclocking and 30us.
Set drives to mode 6 with Silicon Image's SATARaid utility.
Uninstalled 3dmark03 and rebooted.
Installed 3dmark03 and ran. Corruption!
Uninstalled 3dmark03 and rebooted.
Set EXT-P2P's Discard Time to 1ms in bios setup.
Booted into Windows and installed and ran 3dmark03. No corruption.

This method should allow anyone to find the best settings for their system regardless of drive maker.

http://forum.abit-usa.com/showthread...threadid=10640