Prosim Vas,
mam takovy jden problem kterych bych rad vyresil spise reseni jak to spravne udelat.

mam doma intel pentium 3 , ktera ma frekvenci 600MHz EB jadro Coopermine a mam posledni bios s revizi 1005 mam desku asus p3v4x s chipsetem via apollo pro 133A.

Jedna se o posledni bios dalsi jiny uz neni k updatu ten posledni bios je z tohoto data 06/12/2000-VT694X-P3V4X-00.

Jedba se mi o to ze mam novy hardisk baracudu seageta 80gb ata vyrovnavacka 2MB a z tohoto noveho disku chci bootovat nikoli ze stareho disku ktery jeste mam v pc a budu ho tam mit.

mam doma knizku o tom biosu kde je napsano ze je dobre nejprve udelat update biosu ale to uz neni mozno protoze se jednalo o posledne vydany bios.

chci aby MBR bylo z toho novyho 80gb disku. ale nevim jak to nastavit v biosu zkousel jsem to ale ty dve hodnoty nelze prohodit jak mate

primary master a primary slave jak to prohodite za pomoci + ci - to tam nemam, ale musim dat enter a mam tam na vyber : 1) auto
2)none
3user type hdd

prosim poradte mi jak to nastavim v mem biosu pokud nekdo neco taoveho jeste ma jinak se jedna o desku asus

na zaver napisu co tam mam napsano v anglictine k tomu primary master a primary slave


before attempting to configure a hard disk drive, make sure you have the configuration inforation supplied by the manufactutrer of the drive. incorrect setings may cause your system to not recognize the installed hard disk. To allow the bios to detect the drive type automatically, select(auto)


type(auto)
select(auto) to automatically detect an idehard disk drive. if automatic detection is succesful, the correct values will be filledin for the remaining fields on this sub menu. if automatic detection fails, your hard disk drive may be too old or too new. you can try updating your bios or enter the ide
hard disk drive parametrs manually.

after the ide hard disk drive information has been entered into bios, new ide hard disk drivee must be partitioned
(such as with fdisk) and then formatted before data can be read from and write on. primary ide hard disk drives must have its partition set to active

(also possble with FDISK)