Integrácia SP1 do Windows Vista

[pegass]

Zdravím všetkých. Skúšali ste niekto integrovať SP1 RC do Win Vista? Cez vLite to nieje možné, ale našiel som návod ako to spraviť, len mi tam nie je celkom jasný 5. a 6.bod. Ten imagex mám odkiaľ spustiť
Viete my s tým poradiť? Diky.

1. Install Vista RTM to a secondary partition (not the main boot partition). The primary reason for this is one doesn't want all the boot associated files of that computer related to BCD and boot.ini being part of the final image.
2. Once in the Out of Box Experience (OOBE) after setup, type Ctrl-Shift-F3 to enter Audit mode. In case you're wondering what/where OOBE is, it is the part after setup where the user is setting up his/her username, password etc.
3. The system will then reboot into Audit mode and a Sysprep window will pop up. Do not close the Sysprep window.
4. Run the Vista SP1 installer and let it do its thing.
5. After the SP1 setup is complete, you'll find yourself back at the main Vista desktop with the Sysprep window open and SP1 will be installed and ready to go. From the Sysprep selection window, select OOBE, Generalize, and to Shut Down the system.
6. Boot the system into a WinPE disk or another OS install (ie. XP), do NOT boot back into Vista, and run the following imagex command (imagex can be found in WAIK):

imagex /compress maximum /flags "Business" /capture d: c:\install.wim "Windows Vista Business"

where d: is the drive Vista is installed on and c:\install.wim is the location to store the new install.wim. Replace "Business" with whatever edition of Vista you are installing and replace the drive letters with your own.
7. Once the image has been built, replace the old install.wim in the Vista RTM ISO in \Sources\ with the newly created install.wim using a registered version of UltraISO (Version 8.0 or higher). Save the ISO and you're done.

[pegass]

Tak sa mi to nakoniec podarilo, mám Vista Ultimate SK SP1 RC v.668 osekané cez vLite na 915MB. Zatiaľ všetko šlape ok.

Postup bol v podstate taký istý:

1. Nainštalovať Vistu na druhú, resp. inú partíciu, nie na hlavnú bootovaciu.
2. V časti kedy Vista pýta Meno užívateľa a heslo treba stlačiť CTRL+SHIFT+F3
3. Systém sa následne reštartuje do Audit-módu, kde bude otvorené Sysprep okno
4. Pustiť inštaláciu SP1 RC (systém sa niekoľkokrát reštartuje a nakoniec sa ukáže plocha s otvoreným Sysprep oknom)
5. Tam som zaškrtol políčko Zovšeobecniť a vybral reštartovať.
6. Potom som spustil Vistu na hlavnej partícii, nainštaloval som WAIK, nainštaloval sa tak imagex.
7. Ten som spustil cez príkazový riadok s parametrami
imagex /compress maximum /flags "Ultimate" /capture d: c:\install.wim "Windows Vista Ultimate"

kde d: je partícia s Vista SP1, c: partícia kde sa nám uloží obraz install.wim.

7. Nakoniec cez UltraISO som vymenil súbor install.wim, uložil a hotovo.