Citace Původně odeslal falcon5
No prave , ja mam jen R9500 se 4 a tim bych urcite vykonu pridal ne, kdyz by to frcelo jako plna R9500Pro tedy s 8 pipelines
Souhlas - zmenou odporu pridas 4 pipeliny -> R9500Pro, pak tam soupnes odemknutej bios http://home.mindspring.com/~warp11/95np64.bin -> core az 370MHz.

Jako plna R9500Pro to sice frcet nebude (mas jen 64MB), ale i tak to bude rozdil.

EDIT: s tim biosem si nejsem jistej, nejspis si na ten spravnej - R9500 "Pro" 64MB - jeste musis pockat.

EDIT2: Vytrzeno z diskusniho fora Rage3D:

I've tried the mod on my Club3D 9500 64MB. To change the resistor i used a Weller hot air soldering iron with the hot air tip (works great on smd). I get a 3DMark (no SE) of 12000 now (was 8000).

But!! Ut2k3 bench fails at 2nd flyby. It runs for a few seconds with a garbled screen and then locks up.

My guess is that the driver assumes the card has 128mb when it sees it has 8 pipelines.