Windows XP - zmena IDE na RAID (/AHCI)

Nasel sem po delsi dobe na netu postup, jak bez reinstalu zmenit nastaveni radice. Nevim zda to tu uz nekde neni, ale quick search nic nenasel.

=> pokud mate nejaky duvod proc to udelat, prikladam dve varianty reg souboru, me stacilo pouzit ten s "RAID" v nazvu, nic jineho sem delat nemusel a widle vpohode nastartovaly.

Nasel sem to v en a de, soubory pochazeji z tech linku.

Citace:

---

1. Go to Start, Run, iata75_cd.exe -a -a
This will appear to run as normal setup, but will actually just extract the needed files to \Program Files\Intel\Intel Matrix Storage Manager\Driver
Note: For 64-bit Windows versions, chose the iaStor.sys from \Driver64\ instead of \Driver\.
Copy the iaStor.sys from there to \Windows\System32\Drivers\

2. Double-click the downloaded ICH9R-AHCI.reg file. A safety question should pop up, answer yes.

3. Now reboot your system. Go directly into the BIOS menu, change SATA controller mode from IDE to AHCI or RAID. Exit & save changes.

4. Boot into windows. It will detect new hardware now, cancel that wizard.
Instead start the downloaded Intel Storage Manager Software (iata75_cd.exe), this time without any paramaters.
When it is done installing, reboot once again.

5. Now in your device manager Intel (R) ICH9 SATA AHCI Controller (or RAID) should show up.

6. Enjoy.

---

1. sice sem poustel setup a rozbalilo se to do tempu, ale ve finale sem to vlastne vubec nepotreboval.

2. pouzil sem soubor "RAID" (z nemeckeho webu)

3. OK, po tomto uz widle nastartovaly a nasly novy HW vcetne v biosu vytvoreneho R5 svazku.

---
Postup overen na Abit IP35 PRO.